Datcon PQRM5100 11 U I Series, Инструкция по эксплуатации

Страница: 41 / 80

PQRM5100 11 Ux Ix xx xx (PS)
20200205-V1
41
6.16. Digital output, Limit output settings
Function
Here you can set low limit-, high limit values and hysteresis
and assign them to any measured quantity. The instrument
compares continuously this quantity to the measured value
and activates digital output(s) according the output settings.
1. Click on the ”Configuration” tab
2. Inside of ”Configuration” tab click on the “Module 1” tab.
3. Select the “Limit signal” function on “Function” pull-down
menu.
4. Select the output polarity from the “Polarity” pull-down
menu. When you select the “NO (Normally open)” state
then the output transistor is in off state when there is no
pulse on the output. When you select the “NC (Normally
closed” state then the output transistor is in on state when
there is no pulse on the output.
Sequence of operations
5. Select the desired quantity from the “Measured value”
pull-down menu which on you is going to apply the limit
function.