Datcon DT9100 B, Руководство по эксплуатации

Страница: 51 / 63

DT9100 B

Use supervisor
Code
Setting the synchronisation time ( S ynchron T ime)
Here you can preset the synchronisation time for a remote
synchronising function.
(The seconds are set to zero automatically.)

Use supervisor
code
Setting the synchronisation pulse width ( S ynchron Gate
Time S et)
Here you can set the pulse width of a remote
synchronisation signal. When the active state of the
synchronising pulse is lower then this value, the instrument
doesn’t accept it as a synchronisation pulse.
E.g. when

is selected, then you should keep
terminals 7 and 8 closed for more than 2 seconds before
opening it to activate the synchronisation.

Use supervisor
code
1. digital output mode ( O utput 1 )
Here you can set Out1 (terminal 1 and 2) digital output
mode.
You can use it for synchronising other clocks by selecting
the repeater function.

Use supervisor
code
2. digital output mode ( O utput 2)
Here you can set Out2 (terminal 3 and 4) digital output
mode.
You can use it for synchronising other clocks by selecting
the repeater function.
20180905-V1
51