Datcon DT9000, Руководство по эксплуатации

Страница: 19 / 96

DT9000
20171205-V2
19
Make sure before connection that the current loop is
switched off.
The push-in direct connector assemblies used allow a fast
connection of the cables.
Their proper usage is shown by the following figure: Connecting the cables
into the terminal
assemblies
1. Push the stripped cable-end until it possible into the
terminal assembly. In the case of flexible cable-ends, you
can facilitate opening the connection part by pushing down
the white button.
2. By pushing the wire in, the self-closing connection is
being established. Check it by pulling it outwards slightly.
(3. When you disassemble the cable, push down the white
button by a screwdriver, and pull the cable-end out.)
There is no need to use great force for pushing the cable
in, neither for removal. The button can be pushed down
easily. Please do not exercise forces higher than
necessary, as it may cause damages to the terminal
assembly.