Datcon DT4120 PS Series, Руководство по эксплуатации

Страница: 73 / 92

DT4120 xx xx (PS)
20170324-V0
73
Potentiometer display
decimal point setting
12. Keep stepping by pressing the ▲ button as long as you
see this menu item:

. Here you can assign the
position to 100%. The numerical value is blinking.
Enter the menu item by pressing the
ENTER button.
13. You can see on the display the measured potentiometer
resistance in two decimal format. Changing the
potentiometer position you can see the resistance change
on the display.
14. Set the potentiometer wiper to the desired end position.
15. After stabilizing the displayed resistance value press the
ENTER button.
16. You can see on the display:

. The message is
blinking it signs that it can be modify.
(17. You can exit from this menu item by pressing the
MENU button.)
18. If you want to assign this position to 100%, press ▲
button. You can see on the display:

.
19. Press ENTER button, the caliblation process is ready.
You can see

( Ready = ready), than

message on the display.
20. When you are going to display the potentiometer
position in 0-100% format, the procedure is ready, you can
exit from this menu item by using procedure “
Exit from
menu item” .
When you are going to scale the 0-100% display range use
the „

= Po tentiometer Sca le: potentiometer scale
menu item. Here you can scale the above range.
21. Keep stepping by pressing the
▲ button as long as you
see this menu item:

( P otentiometer Dec imal
P oint = potenctiometer decimal point).
Here you can set the decimal point position of the scaled 5
digit displayed value. Enter the menu item by pressing the
ENTER button.