Datavideo NVS-25, Инструкция по эксплуатации

Страница: 29 / 52

H.264 Network Video Streaming Server
NVS-25
29
10. Setting > Network Setup
On the Network Setup page, the user is able to configure the basic network settings on
the NVS-25. The two available modes are DHCP and True Static. In DHCP mode, the
NVS-25 is randomly assigned an IP address. In True Static mode, the user is allowed to
assign a fixed IP address to the NVS-25. Please note that in a non-DHCP environment,
the user is allowed to reset the NVS-25, which will then be assigned a default IP
address of 192.168.1.20. For instructions on how to reset the device, please refer to the
“
Restore Default ” section.
10.1 DHCP Enable
If DHCP mode is enabled, NVS-25 will attempt to obtain an IP address automatically
from the DHCP server upon connection to an office LAN or the router.
IP address
obtained in DHCP mode changes every time when NVS-25 is power cycled. The IP
address assigned to NVS-25 has the same network prefix as the office network or the
router.
Please refer to the IP finder section for more information on how to locate
NVS-25 on a DHCP network.
10.2 DHCP Disable
If DHCP mode is disabled, NVS-25 will be set to True Static mode. A true static IP
address does not change even after the unit is power cycled. This allows NVS-25 to
be easily located on the network.
If you wish to work in true static mode on your office network, please consult your local
network administrator or IT support for advice. They are also able to confirm the IP
address of the
Default Gateway .
The network setting should persist through the firmware upgrade process. Please refer
to the
Firmware Upgrade section for the process.