11
Master Pedestal Control
These buttons are used to adjust the level of the Master Pedestal.
Enable & Painting Adjustment buttons
Press the ENABLE button in the
Painting area
of the MCU-200P
before choosing to adjust either the level of the Red and Blue Gain
or the RGB Pedestal values.
Mini B USB 2.0 port
This port is used for firmware updates or to save/transfer MCU-
200P settings to computer.
CHECK / Lock
GAIN value, SHUTTER speed, FILTER position, IRIS, Master Pedestal,
R/B Gain and R/G/B Pedestal values are shown on the display
below in this order each time the CHECK button is pressed.
If the CHECK button is pressed and held down for over two seconds
the MCU-200P unit will switch in to LOCK mode.
LED display
The Iris value, Shutter degree, speed, Gain and Filter positions can
be displayed here by using the CHECK button. The M. PED,
PAINTING GAIN R/B and BLACK R/G/B values can also be displayed
sequentially here. See also
CHECK
buttons.
When in
LOCK
mode this display will show Lock.
EXT LED
This LED will be ON when a lens extender is detected on the chosen
camera.
IRIS control
Used to adjust the Iris value. See IRIS and CHECK buttons also.
IRIS button
To enable or disable Auto Iris.
The button is back lit orange when Auto Iris is enabled.
