Datavideo HS-1600T, Инструкция по эксплуатации

Страница: 78 / 96

78

The two buttons turn solid white a few seconds after displaying the operation mode.
Switching operation modes
Follow the steps below to switch to the next operation mode:

First make sure the stream and record functions are in idle state, i.e. STREAM and RECORD
buttons are solid white.

Simultaneously press and hold the RECORD and STREAM buttons for more than 3 seconds but
less than 10 seconds.

As the operation mode switches, both the RECORD and STREAM buttons turn from solid red,
then blinking red and finally to solid white.

When the RECORD and STREAM buttons turn solid white, it indicates that the NVS-31 has
been switched to the next operation mode successfully.
Note: The order of the operation mode change is Stream & Record

Stream Only

Record Only
Checking the next operation mode
Follow the steps below to check the operation mode next to the NVS-31’s current operation mode
before switching:

First make sure the stream and record functions are in idle state, i.e. STREAM and RECORD
buttons are solid white.

Simultaneously press and hold the RECORD and STREAM buttons for more than 1 second but
less than 3 seconds.

The button LED should behave according to the device’s next operation mode. The LED
behaviors are summarized in the table below:
Solid red RECORD button Solid white RECORD button
Solid red STREAM button Stream & Record Stream Only Mode
Solid white STREAM button Record Only Mode None

The two buttons turn solid white a few seconds after displaying the operation mode.
Note: The order of the operation mode change is Stream & Record

Stream Only

Record Only
6.5 Restoring Factory Defaults
Follow the steps below to restore the NVS-31’s factory defaults.
Two Button Model

The RECORD and STREAM buttons are either solid white and solid red, which means the
factory defaults can be restored regardless of the state of the device.

Press and hold the RECORD and STREAM buttons simultaneously for more than 10 seconds.

While the NVS-31’s factory defaults are being restored, the RECORD and STREAM buttons turn
from solid red, then blinking red and finally to solid white.

When the RECORD and STREAM buttons turn solid white, it indicates that the NVS-31’s factory
defaults have been successfully restored.