PAGE16
PAGE17
12.0 - REMOTE CONTROL
The remote control has 2 different function buttons each of which corresponds
to a control signal that activates a selected action according to the operational
condition and alarm configuration.
The textured button is for arming/disarming the alarm while the smooth button
is used to exclude or trigger the siren.
Button 1
LED
indicator
Button 2
Button 1
Button
:
2:
• Arm/disarm alarm unit
• Trigger/Stop p
alarm
• Exclude siren (mute alarm)
anic
• Activate Hazard lights
Separate the shell
halves taking care
not to damage the
internal circuit.
Close the plastic
shells and make
sure the remote
works properly.
Remove the
discharged batteries
and insert the new
ones taking care not to
invert the polarity.
13.0 - WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT
The present device falls within the field of application of the current WEEE
Directive. The crossed-out wheeled bin symbol on the equipment or on its
packaging indicates that the product, at the end of its useful life, must be
discarded separately from other waste to allow adequate treatment and
recycling.
The user must therefore take the equipment, at the end of its useful life, to an
appropriate waste collection facility.
The remote control has a low charge battery indicator that gives you early
warning to avoid malfunctioning. When the batteries are fully charged, the LED
will show a steady light at the press of a button. If the batteries are too weak for
normal operation, the LED will start blinking at the press of a button. To replace
the batteries proceed as follows:
BATTERIES
12 Vdc
< 1mA (alarm armed and LED flashing)
< 1µA
118 dBA @ 1 meter
8A
14.0 - TECHNICAL SPECIFICATIONS
Nominal supply voltage
Load @ 12Vdc
Load in sleep mode
Siren output level
Relay capacity
WARNING
!
U
.
se only CR1616 batteries.
Different type batteries can seriously damage the remote control unit.
Discard used batteries properly in special dedicated containers
