Datastrip EasyRead, Руководство пользователя

Страница: 10 / 41

4209-00009-000 EasyRead (DSV3-EP) User’s Manual Rev 0E
6/29/2009
9
Copyright © 2009 by Datastrip, Inc. All rights reserved.
Reproduction in whole or in part is prohibited.
External Power
Connected?
Battery
Charge State
Power Status
LED Color
Power Status LED Blink Rate
System Powered OFF
Yes No Battery Green Very Slow Blink
Yes Charging Green / Red Continuous with Slow Color Blink
Yes Fully Charged Green Very Slow
WinCE Running
No OK / Not Low Green Slow Blink
No Low Red / Green Continuous with Color Toggle
Yes No Battery Green Solid
Yes Charging Green / Red Continuous with Color Blink
Yes Fully Charged Green Solid
System In Suspend Mode
No OK / Not Low Yellow Slow Blink
No Low Red / Yellow Continuous with Color Toggle
Yes No Battery Yellow Solid
Yes Charging Yellow / Red Continuous with Color Blink
Yes Fully Charged Yellow Solid
Definitions
•
Solid : LED is ON continuously.
•
Slow Blink : LED is ON 50% of the time, blinking every 2.5 seconds (50% duty cycle, 2.5 sec period).
•
Very Slow Blink : Mostly dark with quick blink approx every 5 seconds (~1% duty cycle, 5 sec period).
•
Continuous with Slow Color Blink : LED is ON continuously with a 5 sec period, where color 1 is ON for 4.9 sec
and color 2 is ON for 0.1 sec.
•
Continuous with Color Blink : LED is ON continuously, with a 2.5 sec period, where color 1 is ON 2 sec, and
color 2 is ON 0.5 sec.
•
Continuous with Color Toggle : LED is ON continuously, alternating evenly between the two colors (50% Duty
Cycle, 2.5 sec Period).
4.4 Battery Charging and Replacement
The terminal uses one 5000 mAH Lithium Polymer battery pack. Under normal operating conditions, the
battery does not need to be removed. The terminal has an internal charging circuit that will charge the
battery whenever the unit is connected to the external AC power adapter.
If the user does want to replace the battery, it may be replaced when the unit is off, or the battery may be
hot swapped when the unit is in Suspend mode. To hot swap the battery, save any work in progress and
put the unit into Suspend by tapping the power button (or via the Suspend command on the Start Menu).
Turn the quick release (quarter-turn) bails on the battery access cover on the rear of the unit. Remove the
old battery and replace it with a charged battery within 30 seconds to prevent the unit from shutting down.
Replace the battery-access cover and re-fasten it by tightening the quick release bails.
Quick Release
Receptacles
Quick Release
Bails
Quick Release
Receptacles
Quick Release
Bails
EasyRead (DSV3-EP) EasyVerify (DSV3-SP)