Revision No. 005 August 2020
DataRemote 2020
1. Remove the DRI-9080 device:
2. Insert power cord into power outlet (located on the rear right side of the DRI-9080 device). Plug
the power cord into an AC power outlet.
3. Once the DataRemote DRI-9080 device is plugged int, install the device mounting screws in the
selected location. Dress and secure the
DataRemote’s AC adapter and power cables path neatly.
Then secure device to the mounting screws. If there are any questions with the device
placement, please contact your Installation Support Team.
4. If the device is not plugged into its permanent power outlet, move the power plug to its
permanent AC power; verify correct LED lights on the DataRemote DRI-9080 device.
WAN (Wired Broadband)
– WAN link light is on Check to see all SIM lights (SIM, DCD, and SVC) are
on and the SIM signal strength bars are lit. (1-3, 3 being the strongest). Wi-Fi AP or Client LEDs are
lit for 2.4G and/or 5G respectively.
Verify Line Registration with FXS LEDs
PHASE 1
DATAREMOTE DRI-9890 DEVICE ASSEMBLY
/PRE-TEST + FIRE PANEL LOCATION.
WAN CONNECTIVITY VERIFICATION VIA LED LIGHT
NOTE:
ANY VARIATIONS FROM THE ABOVE, CONTACT YOUR INSTALLATION SUPPORT TEAM.
ASSEMBLE THE DATAREMOTE DRI-9080 DEVICE TO PRE-TEST:
