10
Scanner Menu Item
Description
REDUNDANCY LEVEL
Ensures bar code integrity by specifying a redundant read count.
(1X – 6X)
READ BARCODE 2X
This count (1 – 6) sets the number of consecutive and identical decodes
that must occur for a bar code to pass.
AUTO
Operation switches to MIN READABLE HEIGHT.
IGNORE NO DATA
Allows an override of the verification function, where:
DISABLED
Checks for correct bar code data in the bar code(s).
ENABLED
Ignores the data present in the bar code(s).
SET DEFAULTS
Restores the Linear Scanner settings to the factory default values.
YES / NO
Selecting YES will return these settings:
MODE = Auto
BARCODES = All, except IATA and codes with certain addendums
BAR CODE COUNT = 00 (Auto Mode)
MIN READABLE HEIGHT = Disabled
REDUNDANCY LEVEL = 2X
IGNORE NO DATA = Disabled
To change FAULT HANDLING settings –
1) Press
MENU
. Press
DOWN
or
UP
to scroll to SYSTEM SETTINGS, and then press
ENTER
.
2) Scroll to FAULT HANDLING and then press
ENTER
.
(See table below for listing.)
3) When finished, press
EXIT
and then
YES
at the SAVE CHANGES prompt to complete setup.
Fault Handling Menu Item
Description
LEVEL
Determines the amount of interaction required to proceed after a fault.
NO REPRINT
Printing stops and a fault message is displayed. Following correction of the
problem,
FEED
must be pressed to clear the fault, but the label in process is
not reprinted.
STANDARD
Printing stops and a fault message is displayed. Following correction of the
problem,
FEED
must be pressed to clear the fault then the label in process is
reprinted.
VOID AND RETRY
Depending upon the RETRY COUNT (see below), one of the following:
•
If the count has not been exceeded, VOID is printed (see VOID
DISTANCE) on the failed label and reprinting automatically occurs;
•
If the count has been exceeded, printing stops and a fault message is
displayed. Following correction of the problem,
FEED
must be pressed to
clear the fault before the label in process is reprinted; or,
•
If
CANCEL
is pressed, reprinting is optional: to reprint, press
NO
; or, to
cancel the reprint, press
YES
(and press YES again to cancel the batch.)
(continued)
