3
6” and 8” printers only
B)
Using a Cotton Swab or cloth, moistened with isopropyl alcohol, gently clean the surface where the
Static Brush will be installed.
WARNING
Isopropyl alcohol is a flammable solvent; always take the proper precautions when using this substance.
C)
Peel the backing from the adhesive strip on
the back of the
Static Brush
and affix the
brush to the printer in the location shown.
Be sure to locate the
Static Brush
as
close to the printer’s Centerplate as
possible.
Static
Brush
Note: The Static brush should be installed so the bristles are as close to the ribbon without actually touching. It
may be necessary to install a roll of ribbon in order to properly align the brush to the ribbon.
Step 3: Configuring the Printer
Note: During this procedure, consult the Operator’s Manual for detailed front panel instructions.
Configure the printer for the thermal transfer use as follows:
A)
Plug the power cord into the
AC Receptacle
and turn ‘On’ the
Power Switch
.
B)
Press the
MENU Button
on the printer’s front panel.
C)
Press the
ENTER Key
to select
MEDIA SETTINGS
, and press the key again to select
MEDIA TYPE
.
D)
Using the
DOWN Button
, scroll to
THERMAL TRANSFER
then press the
ENTER Key
.
E)
Press the
EXIT Key
and then, at the
SAVE CHANGES?
prompt, press
YES
.