QUICK REFERENCE GUIDE
4
DIAGNOSTIC FUNCTION
Light Curtain operating status is visualized through a LED User Interface present on both the receiver and emitter
units. The figures show all LEDs signaling modes: OFF, ON, and BLINKING.
The operator can evaluate the main causes of the system stop or failure through the display and signaling LEDs.
RX side
Alignment
not aligned,
SYNC not
engaged
Refer to "
for correct Alignment Procedure or
properly connect RESTART input on TX
unit to enter Normal Operation mode
(see “Commissioning and Configuration”
in Instruction Manual)
Minimum sig-
nal level,
SYNC engaged
maximum sig-
nal level
Normal
operation
Manual
restart only
Interlock free
beams
Press RESTART button for at least 0.5sec
to restart ESPE in Normal Operation
Normal
operation
OSSD ON
Normal operation
OSSD OFF
Safe status, remove any blocking object
or correctly align the ESPE
EDM active
EDM Function Enabled
Lockout
error
F1: failure on
microprocessor
Internal Failure, check for operating con-
dition (see “Technical data” in Instruction
Manual)) and any cause of electrical
interference, power cycle the ESPE
F2: failure on
optics
Failure on optic scan, check for any cause
of optical and electrical interference,
power cycle the ESPE
F3: failure on
EDM
Failure on EDM, check connection to
relay (see “EDM function” in Instruction
Manual), then power cycle the ESPE
F12: cascade
failure
Failure on cascade communication,
check cascade connection or terminator
cap fixing (see "
F13: failure on
restart
Failure on Restart function, check for
Restart Button connection and any cause
of optical interference, then power cycle
the ESPE
F23: failure on
OSSDs
Failure on Safety Outputs, check for
proper connection (see "
) and any cause of electrical inter-
ference, then power cycle the ESPE
Power supply
failure
Check for proper connection (see "
If failure persists after recommended checks and ESPE power cycle, please contact DATALOGIC.
ESPE
WORKING
MODE
INDICATION
LED CONFIGURATION
RECOMMENDATIONS
