Datalogic SG4 FIELDBUS Series Скачать руководство пользователя страница 8

 

ORIGINAL INSTRUCTIONS (ref. 2006/42/EC) 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

CE Compliance 

 
CE marking states the compliance of the product with essential requirements listed in the applicable European directive. 
Since the directives and applicable standards are subject to continuous updates, and since Datalogic promptly adopts 
these updates, therefore the EU declaration of conformity is a living document. The EU declaration of conformity is 
available for competent authorities and customers through Datalogic commercial reference contacts. Since April 20

th

2016 the main European directives applicable to Datalogic products require inclusion of an adequate analysis and 
assessment of the risk(s). This evaluation was carried out in relation to the applicable points of the standards listed in the 
Declaration of Conformity. Datalogic products are mainly designed for integration purposes into more complex systems. 
For this reason it is under the responsibility of the system integrator to do a new risk assessment regarding the final 
installation. 
 

Warning 

This is a Class A product. In a domestic environment this product may cause radio interference in which case the user 
may be required to take adequate measures. 
 

Datalogic S.r.l. 

Via S. Vitalino 13 - 40012 Calderara di Reno - Italy 
Tel: +39 051 3147011 - Fax: +39 051 3147205 - www.datalogic.com

 

 

Helpful links at www.datalogic.com: 

Contact Us,

 

Terms and Conditions,

 

Support

 
The warranty period for this product is 36 months. See General Terms and Conditions of Sales for further details. 
 

© 2017 - 2018 Datalogic S.p.A. and/or its affiliates 

 ALL RIGHTS RESERVED 

 Without limiting the rights under copyright, no part of 

this documentation may be reproduced, stored in or introduced into a retrieval system, or transmitted in any form or by any means, or 
for any purpose, without the express written permission of Datalogic S.p.A. and/or its affiliates. Datalogic and the Datalogic logo are 
registered trademarks of Datalogic S.p.A. in many countries, including the U.S.A. and the E.U. All other trademarks and brands are 
property of their respective owners. Datalogic reserves the right to make modifications and improvements without prior notification. 

 

821004283 Rev. C

 

Содержание SG4 FIELDBUS Series









Отзывы: