5
SET Button: 0.04 seconds "Click" 0.8 seconds
Remote Input: 0.04 seconds T 0.8 seconds
ADJUST MODE
Sliding the RUN/PRG/ADJ mode switch to the ADJ position allows the user to perform Expert TEACH/SET methods and Manual Adjustment
of the threshold(s).
Two-Point TEACH
•
Establishes a single switching threshold
•
Threshold can be adjusted using "+" and "-" Navigation key (Manual Adjust)
Two-Point TEACH is used when two conditions can be presented statically to the sensor.
The sensor locates a single sensing threshold (the switch point) midway between the two taught conditions, with the Output ON condition on
one side, and the Output OFF condition on the other (see Fig.2).
Darkest Taught
Condition
Sensor positions
threshold midway
Lightest Taught
Condition
between taught conditions
Output OFF
Output ON
Darkest
(no signal)
Position
adjusted by
Manual Adjust
Most Light
(saturated
signal)
Figure 2. Two-Point TEACH (Light Operate shown)
The Output ON and OFF conditions can be reversed by using the LO/DO (Light Operate / Dark Operate) switch
(see
LO/DO Switch
in
Top Panel Interface
).
Two-Point TEACH and Manual Adjust
Moves switching threshold value up or down to make adjustments
•
Slide Mode switch to ADJ to enter Adjust mode
•
Press "+" to increase; press "-" to decrease
- GREEN display shows the switching threshold value
- 2 seconds after adjustment, the GREEN display will flash 3 times to confirm
•
Slide Mode switch to RUN to complete operation
Follow these steps to perform a Two-Point TEACH:
1.
Enter
Adjust
mode.
Method
Action
Result
SET Button
2
Set the Mode switch to ADJ.
Display: Red - Signal Level;
Green - Threshold
Remote Input
3
No action is required; sensor is ready for
the Two-Point TEACH method
NOTE:
TEACH Selection must be programmed to
2Pt tcH
(see
Program Mode
)
Remember:
Manual adjustments are disabled when Auto Thresholds are ON
2
3
