Datalogic Rhino 10, Руководство по установке

Страница: 14 / 20

Installation Manual Rhino™ 10
10
Attaching the Rhino™ 1
or the Rhino™ 10 to operate, you must provide power from the vehicle DC power supply (12V – 60V) or from an
AC/DC power supply.
ection, so the unit retains power even when the vehicle is
Vehicle Connection
main power connection. Consult your vehicle manufacturer or local representative for the best location to connect to
be disconnected from the Rhino™ 10.
allows for moving the location of the Rhino™ 10 on the vehicle at a
inal. (crimper tool not included)
vehicle chassis.
e end of the fuse holder.
to
0 to Power
F
Positive power should go to a non-switched conn
off.
For vehicles with 12 to 48 VDC power available, the Rhino™ 10 should be connected directly to the battery or to a
power.
1. First run the cable from the Rhino™ 10 to the power connection location and secure the cable at several
points with wire ties. Leave a little slack at the Rhino™ 10 to allow for mount adjustment and for the cable to
2. Disconnect the power cable from the Rhino™ 10.
3. Either cut off any excess cable or coil the excess cable in a convenient location and secure with wire ties.
Coiling the cable is recommended as it
later date.
4. Strip enough of the outside jacket to allow the positive and negative connections to reach.
5. Strip ¼” from the Black wire and crimp to a correct size wire lug to allow connection to the power source
ground term
6. Strip ¼” from the Brown wire and crimp to a correct size wire lug to allow connection to the
7. Strip ¼” from the Blue wire and from both ends of the fuse holder.
8. Crimp the cable splice onto the Blue wire and on
9. Select the correct size wire lug to allow connection to the positive terminal of the power source and crimp on
the other end of the fuse holder.
10. Connect all wires to the proper source.
11. Connect the cable to the Rhino™ 10. The unit will boot up at this point.
Figure 10 – Power Wiring Diagram