Datalogic QuickScan I QM2131, Руководство по продукции

Страница: 306 / 362

296 QuickScan™ I QM21X1 / QBT21X1
The A characters were converted to B characters and the 1 characters were con-
verted to 2 characters. Nothing is done with the last two character pairs, since
they are all FF.
To set Character Conversion:
1. Scan the ENTER/EXIT bar code.
2. Scan the “Configure Character Conversion” bar code.
3. Determine the desired string. Sixteen positions must be determined as in
the above example. Next, turn to the ASCII Chart on the inside back cover
of this manual and find the equivalent hex digits needed to fulfill the
string.
4. Turn to Appendix D, Keypad and scan the bar codes representing the hex
characters determined in the previous step.
5. Scan the ENTER/EXIT bar code to exit Programming Mode.
NOTE
If less than the expected string of 16 characters are selected,
scan the ENTER/EXIT bar code twice to accept the selections
and exit Programming Mode.