Datalogic QuickScan I QM2131, Руководство по продукции

Страница: 19 / 362

Setting Up the Reader
Product Reference Guide 9
Linking the Reader to a Base Station
RF Devices
For RF devices, before configuring the interface it is necessary to link the hand-
held with the base. To link the handheld and the base, press the trigger to wake
it and place it on the base. If the reader was previously linked to another base,
you must first scan the Unlink action command before re-linking to the new
base.
BT Models only
Remember: The mandatory condition for establishing a new linking between a
BT handheld and a BT base is that the handheld is unlinked and they share the
same security configuration. A successful link is indicated by three ascending
tones from the reader. A high-low-high-low tone indicates the link attempt
was unsuccessful. A single green LED flash after this tone indicates no Base
Station was discovered. Two green LED flashes after this tone indicates that
more than one Base Station was discovered and the reader did not link. Three
LED flashes after this tone indicate a security error.
Linking a BT Reader to a PC
The reader can optionally be linked to a Bluetooth-enabled PC with the serial
port profile, in either server mode or client mode.
Linking to a PC in Server Mode (BT Slave Mode)
To link a BT reader in server mode to a Bluetooth-enabled PC, follow these
steps:
1. Install any drivers provided with the Bluetooth adapter.
2. Scan the bar code below to make the scanner visible to the host computer.
3. Use the host computer’s Bluetooth manager to “Discover new devices” and
select "Datalogic Scanner." If you receive an error message, it may be nec-
essary to disable security on the device.
4. Select “connect” on the PC to link the reader to the PC. Use an RS-232 ter-
minal program to see incoming data on the port designated by the com-
puter's Bluetooth manager.
Unlink
Link to a PC in Server Mode