Enter/Exit Programming Mode
234
PowerScan™ PD953X/PBT950X/PM950X
PM950X-ONLY FEATURES
The features in this section are valid only for the PowerScan PM950X Star
model:
•
•
STAR Radio Protocol Timeout
This parameter sets the valid wait time before transmission between the
handheld reader and Base Station is considered failed.
When setting this parameter, take into consideration the radio traffic (num-
ber of readers in the same area). The selectable range for this feature is
from 02 to 25 seconds. See
in “References” for detailed informa-
tion and examples for setting this feature.
Set Radio Protocol Timeout
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by two digits from the Alpha-
numeric characters in
rep-
resenting your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL barcode to abort
and not save the entry string. You can then start
again at the beginning.
~
CANCEL
DEFAULT
02 = 2 Seconds Radio Protocol Timeout
Содержание PowerScan 950X Series
