Datalogic Magellan 9300i, Руководство по продукции

Страница: 90 / 520

78 Magellan™ 9300i / 9400i Scanners
Calibrating the Scale (Pounds & Kilograms)
1. Before proceeding, ensure that the scanner/scale has been prepared for
this process by performing the preceding steps titled,
Preparing the Scan-
ner/Scale for Calibration
2. Verify that there are no obstructions under the weigh platter. Remove the
weigh platter

(L-Platter) and make sure that there are no obstructions in the debris
chutes (see Figure 8 ).
3. If one is present, cut and remove the seal securing the calibration switch
access cover. The seal may not be present if this is the initial installation of
the scanner/scale.
4. Slide the cover to reveal the switch as shown in Figure 45 .
5. Use a long, blunt object, such as the eraser end of a pencil to press and
release the Calibration Switch and place the scanner/scale in Calibration
Mode (see Figure 45 c). The scanner/scale will sound a tone, indicating that
it is in Calibration Mode. The Scale Status (yellow LED) will flash, indicating
the scale is in Calibration Mode. If one is present, the Remote Display will
show the message “ESCL” (empty scale).
6. Reinstall the weigh platter.
7. Press the Scale Zero Button. The Scale Status (yellow LED) will go out for
approximately 10 seconds (or less) and the Remote Display (if present) will
alternately display ---- and ____ until the scale is ready to proceed.
8. When the scale is ready, the Scale Status (yellow LED) begins blinking
again, and the Remote Display (if present) will show the message “Ad20
(add twenty pounds)” or “Ad10 (add ten kilograms).” The scanner/scale
will also sound one tone if the scale is weighing in kilograms or two tones
for pounds if you don’t have a Remote Display.
9. Place the correct weight (twenty pounds for calibration in pounds, or ten
kilograms for metric calibration) from the Field Standard Weight set, onto
the center of the weighing area. Press the Scale Zero Button again.
10.The Scale Status LED extinguishes for approximately 10 seconds and the
Remote

Display (if present) alternately displays ---- and ____ until the scale is
ready to proceed.
11.If the calibration was successful, the speaker sounds a single tone , the
Scale Status LED begins blinking again, and “End-” appears in the Remote
Display (if one is present).
12.If the calibration was not successful, the speaker sounds five tones indi-
cating a scale failure, and the Scale Status LED will blink twice, strobe (fast
blinks), and then continually repeat this sequence until reset. Remove all
weight from the Weigh Platter, and repeat the procedure starting with step
8.
13.Press the Scale Zero Button again to permanently store the calibration data
and exit Calibration Mode. You have completed the calibration of the
scale. The unit’s calibration must now be verified as required by state and/
or local weights and measures regulations. The verification procedure