Datalogic Gryphon I GD4132, Руководство по продукции

Страница: 297 / 354

If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the begin-
ning.
Symbologies
Product Reference Guide 295
5. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Prog Mode.
Set Length 2
This feature allows you to set one of the barcode lengths for the specified sym-
bology. Length 2 is the maximum label length if in Variable Length Mode, or the
second fixed length if in Fixed Length Mode. See the page for the specific sym-
bology for parameters.
The length that can be set varies depending on the symbology. A setting of 0
specifies to ignore this length (only one fixed length).
Follow these instructions to set this feature:
1. Determine the desired character length (from 1 to 50 — or 0 to ignore this
length). Pad the number with leading zeroes to yield two digits. For exam-
ple: 0 = 00, 5 = 05, 20 = 20, etc.
2. Go to the Set Length page for your selected symbology and scan the
ENTER/EXIT PROGRAMMING MODE barcode to enter Programming Mode.
3. Scan the barcode to SELECT LENGTH 2 SETTING for your selected symbol-
ogy.
4. Scan the appropriate two digits from the keypad in Appendix D, Keypad
that represent the length setting which was determined in the steps above.
You will hear a two-beep indication after the last character.
If you make a mistake, before the last character scan the CANCEL bar-
code to abort and not save the entry string. You can then start again
at the beginning.
5. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
Mode.
This completes the procedure.