Datalogic DSM0400, Руководство по продукции

Страница: 62 / 252

Enter/Exit Programming Mode
54 DSM0400 Fixed Mount Area Imager Bar Code Reader
Global Prefix/Suffix
Up to 20 ASCII characters may be added as a prefix (in a position before the bar
code data) and/or as a suffix (in a position following the bar code data).
Set the value “00” (two ‘0’ characters) to have no Global Prefix/Suffix. The
default is <CR> character suffix. See "Global Prefix/Suffix" on Chapter 4, Refer-
ences for more detailed programming instructions.
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from the
Alphanumeric characters in
Appendix C
representing
your desired character(s). End by scanning the ENTER/EXIT
bar code again and then exit programming mode by scan-
ning it one more time.
Set Global Prefix
Set Global Suffix
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix C
represent-
ing your desired character(s). End by scanning the ENTER/
EXIT bar code again and then exit programming mode by
scanning it one more time.
Did you make a mistake? Scan the CANCEL bar code to
abort and not save the entry string. You can then start
again at the beginning.
~
CANCEL
The default is <CR> character suffix. For setting <CR> character as global Suf-
fix, enter Programming Mode, then read the following bar code and then exit
Programming Mode
DEFAULT
Global Suffix: OD (hex code for <CR>)