Datalogic DS2100, Руководство по установке, Страница: 14 / 48

DS2100
2
1
•
test mode to verify the reading features and exact positioning of the scanner
without the need for external tools.
•
programmable in 4 different operating modes to suit the most various barcode
reading system requirements.
•
code verifier
•
low power consumption.
The DS2100 uses a solid state laser diode as a light source; the light emitted has a
wavelength between 630 and 680 nm. Refer to the section “Safety precautions” at
the beginning of this manual for information on laser safety.
The protection class of the enclosure is IP65, the reader is therefore suitable for
industrial environments where high protection against harsh external conditions is
required.
The four LEDs on the side of the scanner indicate the following:
PWR/TXD LED (red) (Figure A, 5) indicates the reader is connected to the
power supply or, when blinking (green), data transmission.
GOOD READ LED (red) (Figure A, 3) is used to signal the possibility of a
successful barcode reading.
EXT TRIG LED (yellow) (Figure A, 4) indicates external trigger activity. Refer
to par. 2.3.4.
LASER ON LED (green) (Figure A, 2) indicates laser ON state.
The screw holes on the body of the reader are for mechanical fixture (Figure A, 1).