Datalogic Controller SC6000, Руководство по установке

Страница: 13 / 22

2.7 REDS PARAMETERS CONFIGURATION
2.7.1 Master Working Controller REDS configuration
After the Net and Scanner setting, complete the Working configuration as follow:
1. Redundancy Parameters Reds Functionality = checked .
2.
Redundancy Parameters Topology Redundancy = Master Working .
3. Data Communication settings Built-in Ethernet Line Parameters IP_address
Active = insert the IP address of your Master Working .
4.
Data Communication settings Built-in Ethernet Line Parameters IP_address
Stand-by = insert the IP address of your Master Protecting .
NOTE
The IP_address Active must be different to the IP_address Stand-by.
The two IP_address must be on the same sub-net.
5. Data Communication settings Built-in Ethernet Line Parameters IP_netmask
= insert the IP netmask .
6. If it is necessary set parameter:
Data Communication settings Built-in Ethernet
Line Parameters IP_ gateway = insert the IP gateway .
7. If it is necessary set parameter:
Data Communication settings Built-in Ethernet
Line Parameters IP_ dns1 = insert the IP dns1 .
8. If it is necessary set parameter:
Data Communication settings Built-in Ethernet
Line Parameters IP_ dns2 = insert the IP dns2 .
For the use of WebSentinel it’s necessary to set the parameters below:
9. Data Communication settings Built-in Ethernet Services SentinelClient
Enable = checked .
10. Data Communication settings Built-in Ethernet Services UserSocket#3
Status = checked .
NOTE
When an UserSocket# is used with WebSentinel, Data Tx must be
unchecked.