Datalogic 959941000, Инструкция по эксплуатации

Страница: 31 / 88

Instruction Manual DataVS1 Series
27
By default the three outputs have the following settings:

OUTPUT 1
: Part pass

OUTPUT 2
: Part pass

OUTPUT 3
: Part Pass
To modify the behaviour of the outputs, move the cursor with the
ARROWS
then use
SET
to select
the desired option.
Each output can also function in negative logic. On enabling this option, the output will behave in the
opposite manner compared to standard mode: that is it will take value 1 instead of 0 and vice-versa.
To enable negative logic simply flag the box next to the output name. To do this, use the
ARROW
buttons to move to the box and press the
SET
button.
The final parameters which can be set regarding the behaviour of digital outputs are
duration
and
delay
. Please note that these parameters are common to all the digital outputs and therefore it is not
possible to set different values for different outputs.

Duration
this indicates the length of time (in ms) the output must maintain the last acquired
value; this is mainly used for Part Present, Part Pass and Part Fail modes.

Delay
indicates after how long the output shall display the last acquired result. It delays the
time the output signal is maintained if the delay is longer than the processing time, therefore
from when the image is acquired to when the outputs are enabled.
These two parameters can be set using the
LEFT/RIGHT ARROW
buttons.
Once the settings have been completed, it is possible to return to the System menu and save the
modifications by pressing the
TEACH
button. Press
ESC
if you wish to exit without saving the
modifications. The system will display save request message. To confirm exit and ignore the
modifications, use the
ARROWS
to reach
NO
and press
SET
.