Data General AViiON Series, Клиентская документация

Страница: 118 / 210

Connecting External Devices to VME Option Boards
4-18
014–001867
Connecting a VTC Controller to an
Ethernet LAN
An Ethernet/IEEE 802.3 local area network (LAN) can incorporate several devices
that communicate over a common system of cables and transceivers. This section
describes how to connect the drop cable between your VTC controller board and its
transceiver on a LAN.
NOTE: For information on setting up the cables and transceivers on your LAN,
refer to Ethernet/IEEE 802.3 Local Area Network Installation Guide.
Figure 4–20 shows the location of the DB15 local area network connector on an
installed VTC board.
LAN connector
(female)
AViiON computer – rear view
RJ45 connector
(for diagnostic use only)
Figure 4–20 VTC LAN Connector
Use one of the drop cables listed in Table 4–5 to connect your LAN transceiver to the
computer.
Table 4–5 LAN Drop Cables, VTC
Cable Type Part Number Model Number Cable Length (m)
gr
005–33791 1326 5 (16.4 ft)
Plenum-grade
005–33787 1326A 20 (65.6 ft)
C
007–5414 40028 1 (3.3 ft)
C
007–6253 40028A 3 (9.9 ft)
PVC
005–33766 15274E005 5 (16.4 ft)
005–31694 15274E020 20 (65.6 ft)