Data General 6675, Инструкции по установке и эксплуатации

Страница: 11 / 22

Installing the Drive
5
014–001953
Termpower (TPWR) and Parity Checking Jumpers
Refer to your installation or setup manual for your computer. If this manual
specifies a jumper setting different than the factory default setting shown in
Figure 1, use needlenose pliers to install or remove the jumper accordingly. If there
is no mention of the jumper’s function in these manuals, leave the jumper in the
factory default position.
Installing or Removing the Drive Terminator
Resistors
Figure 2 shows the three removable SCSI–bus terminator resistor packs on the
cartridge tape drive. You may need to remove these three terminator resistor packs.
Refer to the installation or setup manual for your AViiON or ECLIPSE computer
system or mass–storage subsystem. In most cases, you must remove these three
terminator resistor packs because AViiON and ECLIPSE computer systems and
mass–storage subsystems use an external SCSI bus terminator plug. If you need to
remove the resistor packs, use needlenose pliers, as shown in Figure 2. Save the
terminator resistor packs for possible future use. For easy storage, tape the
terminator resistor packs to the drive enclosure.
Pin
identifying
mark
Viewed from top
and front of the
drive
Figure 2 Installing or Removing a Terminator Resistor Pack from the Drive Board