Data Domain DD580, Руководство по аппаратному обеспечению системы

Страница: 72 / 74

Installation
72 System Hardware Guide
Note The slide rails can accommodate a front-to-back rail depth of 28 inches (710 mm) to 33.67
inches (855 mm).
c. Mount the outer rails onto the rack.
d. Slide the system into the rails that are in the rack.
e. Remove the thin, clear plastic wrap that covers the top panel of the system and the clear
plastic tape that covers the top and bottom surfaces of the trim around the front of the
chassis.
f. Slide the system all the way into the rack.
2. Determine whether your configuration and ongoing administration access for the system is to
be through an Ethernet connection, a serial console, or a monitor and keyboard.
Figure 31: Access points
Console port Monitor (VGA) port
Keyboard port
- For an Ethernet connection, attach an Ethernet cable to one of the Ethernet interfaces,
eth0, eth1, or if available, eth2, or eth3 on the back panel. See Figure 34 on page 74 for
Ethernet interface locations.
- For a serial console, attach an RS232 null modem cable to the DB9 port (labeled “Console
Port”) on the back panel. See Figure 31. Use the console communication settings of: 9600
baud, 8 data bits, no parity, 1 stop bit.
- For a monitor and keyboard, attach the monitor to the port labeled VGA and the keyboard
to the port nearest the keyboard icon. See Figure 31 for locations.
3. For backup and restore communications to and from the Data Domain system, attach at least
one Ethernet cable to an Ethernet interface or a Fibre Channel cable to a VTL HBA port on the
back panel. See “System Card Interface” on page 68 for interface locations.