DARLEY
SCREENGUARD STAINLESS STEEL MESH SECURITY SYSTEM
16
Corner Stake Punch – Model HP-160-06K
The process of locking Corner Stakes into security door corners has always been a labour intensive problem.
(Most manufacturers drill the frames and then use pop rivets to secure the corners.)
The use of Reinforced Plastic Corner Stakes has changed the industry - less time consuming - easier to assemble.
The Universal Hole punch is designed to provide an easy and safe solution to enable the screw holes to be
accurately punched in each frame end in about 1 second. Result - a neat clean joint without distortion.
What you get:
Each kit contains the portable Hole Punch , Foot Valve and the necessary tube and fittings.
Specifications:
The machine is designed to crimp the corners of Security Window Frames to the Aluminium Corner Stakes.
The accepted range for frame thickness is 8-12 mm.
(Important - The corner stake thickness should be a tight fit - less than 0.2 mm clearance
.
The operating pressure is a minimum of 7 bar.
Installation Instructions:
1.
Place the corner press onto the bench or wall location.
2.
Connect the tubing between the press and the foot valve.
3.
Connect the air supply to the foot valve and you are ready to go.
Operating Instructions:
1.
Slide the mitred end of the soor section into the press – fully in against the stop
2.
Press the foot pedal to crimp the corner.
3.
Release the foot pedal and remove the frame.
Follow the above procedure for each frame end.
Universal Fluid Power Pty Ltd
A C N 42 050 407 415
+61 7 3202 9000
P O Box 1440, Kenmore, QLD 4069, Australia
Issue date 28/10/2019
Corner Stake Punch - 2916
The process of locking corner stakes into security door corners has always been a labour
intensive problem. Most manufacturers drill the frames and then use pop rivets to secure the
corners.
The use of Reinforced Plastic Corner Stakes has changed the industry - less time consuming -
easier to assemble.
The Universal Holy punch is designed to provide an easy and safe solution to enable the
screw holes to be accurately punched in each frame and end in about 1 second.
What You Get:
Each kit contains the portable Hole Punch, Foot Valve and the neccessary tube and fittings.
The operating pressure is a minimum of 7 bar.
Installation Instructions:
1. Place the corner press onto the bench or wall location.
2. Connect the tubing between the press and the foot valve.
3. Connect the air supply to the foot valve.
Operating Instructions:
1. Slide the mitred end of the door section into the press - fully in against the stop.
2. Press the foot pedal to crimp the corner.
3. Release the foot pedal and remove the frame.
Follow the above procedure for each frame end
