8
3. INSTALLATION
3.1 Unpacking and Inspection
Please open the package and carefully remove the device and its accessories. Check all
materials against the packing list.
•
Check the monitor for any mechanical damage.
•
Check for damaged wires, sockets and accessories.
Contact supplier immediately if there is any problem.
NOTE: Please save the packing case and packaging material for future transport
and storage.
3.2 Connect SpO2
sensor and TEMP Probe
You can connect the SPO2 sensor and TEMP probe to the monitor by simply inserting their
connectors to the SPO2 socket on the monitor’s top side panel as shown in Fig. 1(1,2).
3.3 Connect AC Power Adaptor
Plug the AC adaptor into the mains and. The adaptor’s power indicator LED lights up. Insert the
adaptor’s connector to the adaptor socket on the monitor’s right side as shown in Fig. 1(8).
WARNING: The AC power adaptor supplied is built to special requirements and should
only be used with the monitor. Never use other adaptors else the device could be
damaged and may result in patient injury.
3.4 Power-on
Press the power button and hold for more than 3 seconds to turn on the monitor. The green
LED on the front panel lights up. The LCD screen displays the monitoring mode.
3.5 Computer Data Transfer
The monitor can be connected to a Personal Computer through the serial cable supplied, to
transmit patient trend data to the computer for review and saving. The trend waveforms
can then also be printed.
Connect the serial cable to the socket on the monitor’s right side panel (see Fig 1.9) and the
RS232 connector to the PC’s serial port.