DAPAudio EDGE EHS-1, Руководство пользователя

Страница: 21 / 40

20
EDGE EHS-1
Product code: D1475B
Switching ON/OFF – Transmitter
The transmitter has a power button.
● Press and hold down the power button (18) for 3 seconds to switch the transmitter on/off.
● When in the main menu of the transmitter, press the power button (18) to confirm selections and to
return to the start screen.
Pairing
You can pair the transmitter with the receiver.
Before pairing, scan for unused frequencies to avoid interference. See 5.3.1.4. Scan on page 24.
To automatically pair the receiver with the transmitter, follow the steps below:
Remove the battery cover (19) of the transmitter.
Put the transmitter near the receiver, so that the IR sensor (21) of the transmitter is as close as possible
to the IR sensor (04) of the receiver.
Follow the steps in 5.3.1.5. Synchronization on page 24.
Install the battery cover (19) again on the transmitter.
To manually set the transmitter and the receiver to the same channel and frequency, follow the steps
below:
Select a group on the receiver. See 5.3.1.1. Group on page 23.
Select a channel on the receiver. See 5.3.1.2. Channel on page 23.
Select a frequency on the receiver. See 5.3.1.3. Frequency on page 23.
Select a group on the transmitter. See 5.4.2.1. Group on page 31.
Select a channel on the transmitter. See 5.4.2.2. Channel on page 31.
Select a frequency on the transmitter. See 5.4.2.3. Frequency on page 31.
5. Operation
Safety Instructions for Operation
Attention
This device must be used only for the purposes it is designed for.
This device is intended for use as a wireless handheld system. It is suitable only for indoor installation. It is
not suitable for households.
Any other use, not mentioned under intended use, is regarded as non-intended and incorrect use.
Attention
Power supply
Before connecting the device to the power supply, make sure that the current, voltage and frequency
match the input voltage, current and frequency specified on the information label on the device.