DAPAudio EDGE EHS-1, Руководство пользователя

Страница: 19 / 40

18
EDGE EHS-1
Product code: D1475B
8 x EDGE EHS-1
In a setup with 8 receivers, you can use 2 antenna distributors and 1 set of unidirectional/omnidirectional
antennas.
The antennas receive the signal from the transmitter(s) and send it to the antenna distributor. The
antenna distributor sends the signal to the other connected antenna distributor. Both antenna distributors
send the signal to each connected receiver.
The unidirectional/omnidirectional antennas and the antenna distributor are not supplied with the
device. See 3.5. Optional Accessories on page 11.
Fig. 11
Connecting the Receiver to Mixer/Amplifier
Attention
Connect all data cables before supplying power.
Disconnect power supply before connecting or disconnecting data cables.
The receiver has a balanced 3-pin XLR output connector and an unbalanced ¼
ʺ
/6,3 mm jack output
connector.
To connect the receiver to a mixer or an amplifier:
01) Make sure that the receiver is not connected to power supply and the volume is turned down.
02) Make sure that the mixer or the amplifier are switched off and the volume is turned down.
03) Use a 3-pin XLR audio cable to connect the 3-pin XLR AF balanced OUT (08) of the receiver to the
XLR input connectors of the mixer, or use a ¼
ʺ
mono jack cable to connect the ¼”/6,3 mm jack AF
connector OUT (11) of the receiver to the input connector of the amplifier.