DAPAudio DS-MP-150, Руководство по эксплуатации продукта

Страница: 12 / 23

10
23. Effect On Button:
This button allows you to switch the effect processor on.
24. Effects Selector Button:
Pressing this button allows you to select one of the seven effects as shown below.
Fig. 6
25. Loop In:
Press this button to set the start point of the loop.
26. Parameter 1 Control:
The Parameter 1 and 2 controls allow you to adjust effect parameters. Not all effects require two
Parameter controls.
27. Loop Out:
Press this button to set the endpoint of the loop.
28. Parameter 2:
The Parameter 1 and 2 controls allow you to adjust effect parameters. Note that not all effects require
two parameter controls.
29. Sample Display:
Indicates the selected sample.
Mixer Functions
30. Folder Select
Depending on the browser panel (see page 19) you’re in, you can use the encoder to select a
certain track or folder. Confirm by pressing the encoder.
31. Load A Button:
Pressing this button loads the selected track in the A-deck.
32. Channel A Gain:
Channel input level is determined by the gain control. With the gain control you can boost
the signal of each individual channel. Adjust the input- sensitivity in order to match the incoming
signals to the mixer’s internal operation level.
33/ 34/ 35. Channel A Equalizer Section (HI / MID / LOW):
Use the 3 band equalizer to adjust the tone for each channel by using the Hi, Mid and Low controls.
36. Power LED:
Indicates that the unit is switched on.
37. Channel A Fader:
The fader controls the volume of a the A channel.
38. Crossfader:
The crossfader allows you to mix evenly from one source to another.
39. Folder Out Button:
Pressing this button opens a selected folder.
40. Load B Button:
Pressing this button loads the selected track in the B-deck.
41. Channel B Gain:
Channel input level is determined by the gain control. With the gain control you can boost
the signal of each individual channel. Adjust the input- sensitivity in order to match the incoming
signals to the mixer’s internal operation level.
42/ 43/ 44. Channel B Equalizer SECTION (HI / MID / LOW):
Use the 3 band equalizer to adjust the tone for each channel by using the Hi, Mid and Low controls.
45. VU METER:
The stereo VU Meter allows you to monitor the dB levels of the Left and Right Master output.
46. Channel B Fader:
The fader controls the volume of the B channel.