DAPAudio DM-1000, Руководство пользователя

Страница: 7 / 16

Ordercode: D4212 / D4213
DM-1000 / DM-2000
Frontside
Fig. 01
Power Switch ON/OFF
Flick the switch to turn the DM on/off.
Gain control (CH1)
Turn the control to set the channel’s gain level.
POWER, PARALLEL/BRIDGE, PROTECT, SIG/CLIP LEDs
• POWER: The LED will light up when the DM is switched on.
•
PARALLEL/BRIDGE: The LEDs will light up, depending on which mode is currently active: parallel
or bridge.
•
PROT: The LED will light in red when the amplifier is in protection mode. Switch off the device and
find out what the problem is. The amplifier is protected against overheating, overload, short
circuit, etc. Decrease the source signal level and/or improve air circulation in the room where
the DM is installed.
• SIG/CLIP: When the LED lights in green, it means that the DM is operating within its safety limits.
When the LED lights in red, it indicates distortion. In this case, decrease your source signal level
until the LED turns off. Please keep in mind that the amplifier itself cannot correct any distortion.
Gain control (CH2)
Turn the control to set the channel’s gain level.
Air intake grill
6