DAPAudio D1247, Руководство пользователя

Страница: 12 / 60

11
IR-150BT Media Player
Product code: D1247
Connecting Audio Devices
Connect audio devices to the audio outputs. The device has the following audio outputs: TOSLINK
connector (09), coaxial connector (10), RCA analog line-level connectors (11) and 2 x 3-pin XLR
connectors (13/14). To avoid interference, the IR-150BT Media Player shall be turned off when connecting
devices.
Connect the RCA analog line-level connectors (11) to the audio devices such as, an amplifier, an active
speaker, a console, etc.
If your audio device has digital inputs, connect those to the digital TOSLINK connector (09) or the coaxial
connector (10).
DAB/FM Signal Reception
To receive radio stations in DAB or FM, connect your audio device to the RCA analog line-level
connectors (11) or to the 2 x 3-pin XLR connectors (13/14). The digital outputs TOSLINK connector (09)
and the digital coaxial connector (10) do not work in this operation mode.
Connect a correct antenna (for example, a household aerial antenna) to the DAB/FM wire antenna
connector (12).
If reception conditions are good, you can connect the supplied wire antenna. If possible, put the device
near a window and unwind the antenna.
Installation of the Batteries
The supplied remote control is delivered without batteries. It accepts 2 x AAA 1,5 V (alkaline) batteries.
To install the batteries:
Press on the battery compartment cover and move it down, to open (Fig. 05).
Insert 2 x AAA 1,5 V batteries into the battery housing (Fig. 06).
Close the battery compartment cover (Fig. 07).
Fig. 05 Fig. 06 Fig. 07
Note:
Make sure that you install the batteries with correct polarity orientation.