6
www.danvex.fi
In the course of work through a dehumidifier there is a continuous repeated circulation of air and
its humidity in the room gradually decreases. Due to the design of the dryer in a single unit, the air
temperature at the outlet of the dryer in dehumidification mode is always higher than the air
temperature at the inlet to the dryer by about 5°C.
It should also be borne in mind that the performance of the dehumidifier directly depends on the
humidity and temperature of the air being dried. The lower the temperature and air humidity, dryer
performance will be lower.
The dehumidifier is equipped with a function to control the presence of a removable tank and the
level of its filling. If the tank is empty or full, the display will show "Tank Full" and the dehumidifier
will automatically turn off until the cause is corrected.
To use a removable tank to collect condensate, it is necessary to lead the hose from the condensate
collection tray into the tank. To drain condensate directly into the sewer, it is necessary to connect
the hose from the condensate tray from the inside to the fitting on the side wall of the
dehumidifier, and use the supplied corrugated hose from the fitting to the sewer from the outside.
In this case, the dehumidifier can operate continuously, without stopping to drain the condensate
from a filled tank.
When freezing the heat exchanger during the operation of the dehumidifier, the automation
switches off the compressor for defrosting, the fan continues to work. After the defrosting of the
heat exchanger is completed, the compressor turns on automatically and the air dehumidification
continues. Operating modes are displayed on the LCD display of the control panel.
The dehumidifier is equipped with a removable, washable G3 filter to clean the incoming air. The
use of a dryer without a filter is prohibited due to contamination of the heat exchanger, subsequent
corrosion of its elements and, as a result, depressurization of the system.
Schematic diagram of the dehumidifier operation
2.3
Design
The dehumidifier has a metal, corrosion-resistant housing, powder-coated method.
In the lower part of the body, behind a removable panel, there is a condensate collection tank.
In the upper part of the housing there is an incoming air filter, which is fixed with a removable grille.
Evaporator (cold
heat exchanger)
Condenser (hot
heat exchanger)
Wet air
Wet air
Dehumidified
air
Dehumidified air
Condensate
collection tray
Tank
Fan
Compressor
Evaporator Condenser
Temperature
Humidity
Time
