14
www.danvex.fi
• MAN
-
manual control mode. The dehumidifier operates
continuously without the humidity controller being activated
and until it is turned off by the operator
.
• AUTO
-
automatic control mode. In this mode, the dehumidifier
is automatically controlled by the humidity controller
depending on the set humidity value and the current values
from the remote sensor, which is installed in the room being
dried. The dehumidifier starts when the current humidity
is higher than the one set in the controller and stops when
the set humidity is reached
.
The main control element of the dehumidifier in automatic mode
is
humidity controller
(Humidistat). When the dehumidifier
is operating in automatic mode, the upper panel displays
the current humidity in the zone of installation of the remote
sensor, the lower panel displays the humidity set by the operator
.
Hour meter
displays the total running time (for AD-200 and AD-550 models)
.
Ammeter
displays the current in the recovery air heater circuit (for AD-200)
.
Thermal controller
(Temp. Controller) regulates the temperature on the regeneration air
PTC heater (for model AD-550). The upper digital display shows the current temperature
of the heater, the lower display shows the set temperature
.
It is forbidden to change the preset settings of the temperature controller during
to avoid incorrect operation of the dehumidifier or its failure!
4.2
Humidity controller interface and settings
The humidity controller used in the dehumidifier is a versatile device and can be configured
for use in a dehumidifier or humidifier. During the dehumidifier factory testing, the controller was
configured to work correctly.
However, it is recommended to check the parameters at the first start and change them if necessary.
