Dantherm AC-24, Руководство по обслуживанию

Страница: 23 / 52

Procedure
Step Action
1 Find a suitable location for the air conditioner as described on previous page.
2
Supply ducts.
Connect the flexible air hoses to the evaporator discharge openings ( Cold air
out) and insert the opposite end of the hose to the tent.
If there are any internal distribution hoses in the tent, these can also be
connected.
3 Return ducts.
A return air hose may be connected from the shelter to the evaporator air inlet
(hot air intake) As long as the return air is colder than the ambient air, this will
save cooling capacity.
4 Place the room thermostat inside the tent/shelter at the optimal location.
•
Avoid sunlight
• Avoid direct cold air from the air conditioner ducts
• 1.5 m above the floor
• Near the return air end of the tent/room
5 Make sure that the function switch is set to „OFF“
6 Connect the CEE plug to an external power source.
7 Set function switch to "Auto" and the unit will run using the room thermostat.
8
• Set the desired temperature 
in the shelter by pressing the
buttons  on the thermostat.
Operating range in
cooling mode: 20ºC to 50ºC
See the section: Description of room
thermostat on page 17.


Setup
23
en