P
AGE
16
46517-92-1098 <90-00085>
Here are brief descriptions of the command keys that you can
use while the cursor is in the TRE field.
F1 - GOTO - Goes directly to any TRE entry.
F2 - Alm Pnts - Sets alarm points for each entry. Refer to To
edit alarm points on the next page.
F3 - Blank - Deletes the current entry.
4.
In the Display field, type in the TRE address display number.
Acceptable values are 1-128.
5.
Repeat steps 1-4 to configure additional TRE displays.
6.
When you finish, press F8 to save the information.
To edit alarm points:
1.
In the TRE Display field, select a TRE display number.
NOTE:
If you do not type in the TRE and display numbers for an
entry, you cannot edit alarm points.
2.
Press F2. The Alarm Points screen pops up:
3.
In the AID field, type in the AID attribute. Do not exceed 44 char-
acters.
NOTE:
The AID field is truncated in the Alarm Points listing. When
you select the AID field, you see the entire AID field.
Refer to the AID and EQT Field Command Keys for alarm point
editing.
4.
Press Enter.
NEC GPP SYSTEM DEFINITION
CONTINUED
. . .