Dante DLI1971, Инструкция по установке и эксплуатации, Страница: 16 / 28

5. Index Setup
2. Move the cursor up and down to option, press
enter into the address setting , the range number is 0-255.
1.
, go to as the picture, this set
is aim to set the index of operation address and protocol of the dome.
Use 95 preset or transfer 9 preset twice in three seconds to enter
the main menu COMM SETTING
【 】
【 】 【 】
【 】
【 】
【 】
【 】
SITE ID OPEN
Notice:
Notice:
any control order must based on the aim dome address,
dome only react to the order which address is sam e as its.
A. Common address: the dome only react th e contro l order to the address
wh ich as same as itself, the address range is 1- 254.
B. Broadcast address(only protocol of Factory and PecLo can be set):if the
customer use this address to control the dome, then all the domes control ed
by the system will execute the same action, 255 is broadcast address.
C. Debug address (only protocol of Factory and PecLo can be set) :if the
dome address is 0, then whatever which address was chosen by user can
control the dome.
After all your set, the dome need re-power, after the self-test,then the
setting will be effective.
Enter into the main menu COMM SETTING , move the
joystick up and down, move the cursor to COMM SPEED ,
press OPEN enter into the option of protocol rate of the dome,
the baud rate have four options are 2400bps, 4800bps, 9600bps,
19200bps, choose the one you need, press OPEN to save it .
5. 2 Protocol rate setting
System setting
1 3
SITE ID 001
COMM SPEED 2400bps
BACK
EXIT
MAIN MENU
SYSTEM SETTING
COMM SETTING
FUNCTION SETTING
EXIT
COMM SETTING
SITE ID 001
COMM SPEED 2400bps
BACK
EXIT
COMM SETTING
5. 1 address of dome setting: