Dannmar D4-12, Инструкция по установке и эксплуатации, Страница: 30 / 72

D4-12 Series Four-Post Lifts
30
P/N 5900246 — Rev. B — July 2021
7.
Switching to Lifting Cable C
, repeat Steps 1 through 7 for Lifting Cable C, starting at the
Small Window near the bottom of Post C (the Power Post).
8. Reinstall a Single Cable Sheave and then make sure Lifting Cable C is correctly positioned in the
Cable Sheave in the Small Window.
9. Under the Powerside Runway, move the rest of Lifting Cable C back towards the Crosstube with
Large Windows.
10. Reinstall the Double Cable Sheave in place in the Large Window, making sure Lifting Cable A is
seated in the
Bottom Sheave and Lifting Cable C is seated in the Top Sheave, as shown below.
The following drawing shows the Cable/Cable Sheave pairs in the Crosstube with Large Windows.
Double Cable Sheaves
separated for clarity.
Drawing shows a front
view of the Crosstube with
Large Windows, from
inside of the Lift.
Do not remove the
Retaining Plate or Tie Plate.
Not all components are
shown. Not drawn to
scale.
11. By the Hydraulic Cylinder, loosen the Retaining Plate enough to give you room to slip the Button
End of each Cable into its spot on the Tie Plate.
Do not take the Retaining Plate off
, just loosen the Retaining Plate enough to give you
enough room to slip the Button End of each Lifting Cable into place.
12. Pull the Button Ends of Lifting Cables A and C back towards the middle of the Runway, past the
Retaining Plate, and into its slot on the Tie Plate.
Drawing shows Tie Plate facing
towards the Crosstube with
Large Windows.
Not all components are shown.
Not to scale.
Lifting Cables A and C are now correctly routed to their Posts.
Routing Lifting Cables B and D is the same process as routing Lifting Cables A and C, just to the other
two Posts and using a different set of Sheaves. Refer to the drawings in the previous section.