Dannmar D4-12, Инструкция по установке и эксплуатации, Страница: 29 / 72

D4-12 Series Four-Post Lifts
29
P/N 5900246 — Rev. B — July 2021
2. Route the Threaded End of Lifting Cable A into its Large Window on the Crosstube, push it
towards Post A, and then pull the Threaded End out of the Crosstube at the bottom of the Gusset.
3. Route the Threaded End of Lifting Cable A under where the Gusset Sheave will go when it is
reinstalled, then route it up past the top of the Crosstube Gusset.
The following drawing shows how to route the Lifting Cable through the Gusset.
Important : When routing a Lifting Cable in its Post, the Cable must go
under
the Gusset
Sheave and be on the side of the Slack Safety Sheave. When the Cables are pulled
tight, the Cable prevents the Slack Safety from engaging, which is what you want. If
the Cable is
not in this exact location
, the Slack Safeties will
not
work
correctly.
4. With the Lifting Cable in place, reinstall the Gusset Sheave and the Cable Lock Pin in Post A.
5. Make sure Lifting Cable A is correctly positioned: in between the Gusset Sheave and the Slack
Safety Sheave, with the Cable Lock Pin
under
it.
6. Push the Threaded End of Lifting Cable A up to and through the Top Cap (at the top of the Post)
and
hand tighten
it in place with the Nut and Washer you removed earlier.
You only want to hand tighten the Nut at this point so that there is little play in the cabling. We will
securely tighten all four Nuts later in the installation procedure.
Drawing shows the Threaded end of the
Lifting Cable in position in the Top Cap.
View is from the top of the Post.
Not all components are shown.