Dannmar D-10 Series, Руководство пользователя

Страница: 14 / 52

INSTALLATION INSTRUCTIONS
TOOLS REQUIRED
‡
Rotary Hammer Drill Or Similar (If Anchoring)
‡
3/4” Masonry Bit (If Anchoring)
‡
Hammer
‡ 4 Foot Level
‡ Open End Wrench Set: Metric
‡
Socket And Ratchet Set: Metric
‡
Hex Key / Metric Allen Wrench Set
‡
Large Crescent Wrench
‡
Large Pipe Wrench
‡
Crow Bar
‡ Chalk Line
‡ Medium Flat Screwdriver
‡
Tape Measure : 25 Foot Minimum
‡
Needle Nose Pliers
IMPORTANT NOTICE!
These instructions must be followed to ensure proper installation and operation of your lift. Failure to
comply with these instructions can result in serious bodily harm and void product warranty. Manufacturer
will assume no liability for loss or damage of any kind, expressed or implied resulting from improper
installation or use of this product.
STEP 1
( Selecting Site )
BEFORE INSTALLING YOUR NEW LIFT, CHECK THE FOLLOWING:
1. LIFT LOCATION: Always use architects plans when available. Check layout dimension against floor
plan requirements making sure that adequate space is available.
2. OVERHEAD OBSTRUCTIONS: The area where the lift will be located should be free of overhead
obstructions such as heaters, building supports, electrical lines etc.
3.
DEFECTIVE FLOOR:
Visually inspect the site where the lift is to be installed and check for cracked or
defective concrete.
4.
OPERATING TEMPERATURE.
Operate lift only between temperatures of 41° -104° F.
5. Lift is designed for I
NDOOR INSTALLATION ONLY.
STEP 2
(Floor Requirements)
This lift must be installed on a solid level concrete floor with no more than 3 degrees of slope. Failure to
do so could cause personal injury or death.
DO NOT install this lift on any asphalt surface or any surface other than concrete.
DO NOT
install this lift on expansion seams or on cracked or defective concrete.
DO NOT
install this lift on a second / elevated floor without first consulting building architect.
DO NOT install this lift outdoors.
DANGER
CAUTION
VISIT US ON THE WEB AT WWW.DANNMAR.COM 14