Danish Care Epi-Care free, Инструкция по эксплуатации

Страница: 8 / 16

8
Configuring of an alarm text
The alarm text is configured by sending a text message to the Epi-Care® free
’s
phone
number. The message must start with the text “sat1”, followed by a short
text, for example a name. The alarm text can contain up to 18 characters,
including letters, numbers and spaces.
Example: sat1 John Smith
The alarm text is shown in the text message, are sent during an alarm, and in
messages about possible service disruptions.
Configuration of the alarm text can be omitted, if a text message is not needed.
Configuring of backup number
If a backup number is configured, the Epi-Care® free will direct alarm calls
to the backup number, if the alarm number does not pick up. Configure the
backup number by sending a text message
with the text “sab1”, followed by
the backup number.
Example: sab1 22334455
Configuration of a backup number can be omitted, if it is not needed.
Checking configuration
There are two ways to check the configured alarm number, alarm text and
backup number. The first approach is to enter
the control unit’s menu “GSM
INFO”.
It is also possible to check the configuration by sending a text message to the Epi-
Care®
free’s phone number. The message must start with the text “gau1”.
After approximately one minute, the unit will reply with a text message
containing the information stored on the unit.
Deleting the configured information
The stored information is deletable by sending the following text messages to the
control unit’s phone number:
Delete alarm number: san1
Delete alarm text: sat1
Delete backup number: sab1
Old information is automatically deleted, when new information is configured.
An alarm number MUST always be configured.