SOURCE
|
7
5. SPEAKER SOURCE SETUP (TOGGLE TO LATCH MODE)
[
speaker
source
buttons
pictured
above
]
Feature: Set the desired behavior for the
speaker
source
buttons
: either
toggle
or
latch
mode.
Benefit: Simultaneously press and hold the bracketed
setup
buttons (
an
2
and
aes/spdif
) on the
headphone
source
side. The
setup
lights
will blink. Then press the button with the orange circle (
an
1
) on the
speaker
source
side to switch between
toggle
mode
(button unlit) and
latch
mode (button lit). Press either of the blinking
setup
buttons
(
an
2
or
aes/spdif
) to store and
exit setup mode.
6. SPEAKER SELECTION (TOGGLE OR LATCH MODE)
[
speaker
selection
buttons
pictured
above
]
TOGGLE
Feature: Instantly and silently switch between your speakers using the
speaker
selection
buttons
(
spkr
1
and
spkr
2
) auditioning
only one set of monitors at a time.
Benefit: A/B tracking and mix decisions between two different sets of speakers.
Note:
This is the default setup.
LATCH
Feature: Silently select or deselect any combination of 1 and/or 2 speakers (i.e.
spkr
1
and
spkr
2
).
Benefit: Audition through either set of speakers or both simultaneously (ie. for the control room and live room).
Tip:
,
Use one output for speakers and the other output for a sub (not the sandwich): turn the sub on or off whenever you
need it. (Also, always hear the speakers in full range- some subs have a non bypassable crossover.)
7. SPEAKER SELECTION (TOGGLE TO LATCH MODE)
[
speaker
selection
buttons
pictured
above
]
Feature: Set the desired behavior for the
speaker
selection
buttons
.