![background image](http://html1.mh-extra.com/html/danfoss/vlt-series/vlt-series_programming-manual_3460644034.webp)
0-42 [Auto on] Key on LCP
Option:
Function:
[0]
Disabled
No function
[1]
*
Enabled
[Auto on] Key is enabled
[2]
Password
Avoid unauthorized start in Auto
mode. If
is
included in the My Personal Menu,
then define the password in
Otherwise define the password in
.
[3]
Enabled without
OFF
[4]
Password without
OFF
[5]
Enabled with OFF
[6]
Password with OFF
0-43 [Reset] Key on LCP
Option:
Function:
[0]
Disabled
No function
[1]
*
Enabled
[Reset] Key is enabled
[2]
Password
Avoid unauthorized resetting. If
is included in
the
, then
define the password in
. Otherwise define the
password in
[3]
Enabled without
OFF
[4]
Password without
OFF
[5]
Enabled with OFF
[6]
Password with OFF
3.2.6 0-5* Copy / Save
Copy parameter settings between set-ups and to/from the
LCP.
0-50 LCP Copy
Option:
Function:
[0]
*
No copy
No function
[1]
All to LCP
Copies all parameters in all set-ups from the
frequency converter memory to the LCP
memory. For service purposes it is
recommended to copy all parameters to the
LCP after commissioning.
[2]
All from
LCP
Copies all parameters in all set-ups from the
LCP memory to the frequency converter
memory.
0-50 LCP Copy
Option:
Function:
[3]
Size indep.
from LCP
Copies only the parameters that are
independent of the motor size. The latter
selection can be used to programme several
frequency converters with the same function
without disturbing motor data which are
already set.
This parameter cannot be adjusted while the motor is
running.
0-51 Set-up Copy
Option:
Function:
[0]
*
No copy
No function
[1]
Copy to set-
up 1
Copies all parameters in the present
Programming Set-up (defined in
) to Set-up 1.
[2]
Copy to set-
up 2
Copies all parameters in the present
Programming Set-up (defined in
) to Set-up 2.
[3]
Copy to set-
up 3
Copies all parameters in the present
Programming Set-up (defined in
) to Set-up 3.
[4]
Copy to set-
up 4
Copies all parameters in the present
Programming Set-up (defined in
) to Set-up 4.
[9]
Copy to all
Copies the parameters in the present set-up
over to each of the set-ups 1 to 4.
3.2.7 0-6* Password
0-60 Main Menu Password
Range:
Function:
100
*
[0 - 999 ] Define the password for access to the Main
Menu via the [Main Menu] key. If
is set to
Full
access
[0], this parameter will be ignored.
0-61 Access to Main Menu w/o Password
Option:
Function:
[0]
*
Full access Disables password defined in
.
[1]
Read only Prevent unauthorized editing of Main Menu
parameters.
[2]
No access Prevent unauthorized viewing and editing of
Main Menu parameters.
If
Full access
[0] is selected then
and
will be ignored.
Parameter Description
VLT
®
HVAC Drive Programming Guide
MG.11.CC.02 - VLT
®
is a registered Danfoss trademark
33
3
3