1 Safety Warnings
1.1 Purpose of this Installation Guide
The purpose of this installation guide is to describe the
installation of the VLT
®
OneGearDrive ExtensionBox.
NOTICE
The information is limited to that required for qualified
personnel in normal working situations. Contact Danfoss
for further assistance.
The full operating instructions with more detailed
information are available on the Danfoss website:
vlt-drives.danfoss.com/Support/Technical-Documentation/
Compliance with the information in this installation guide
is a prerequisite for:
•
Trouble-free operation.
•
Recognition of product liability claims.
Therefore, read this manual before working on or with the
OneGearDrive.
VLT
®
is a registered trademark.
1.2 Safety Symbols
The following symbols are used in this manual:
WARNING
Indicates a potentially hazardous situation that could
result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation that could
result in minor or moderate injury. It can also be used to
alert against unsafe practices.
NOTICE
Indicates important information, including situations that
can result in damage to equipment or property.
1.3 Intended Use
The OneGearDrive is intended for commercial installations
unless otherwise expressly agreed. It complies with the
standards of the series EN 60034/DIN VDE 0530. Use in a
potentially explosive atmosphere is forbidden if not
expressly intended for this purpose. The OneGearDrive is
designed for ambient temperatures from –20
˚
C to 40
˚
C
and for installation heights up to 1000 m above sea level.
Danfoss assumes no responsibility of any sort for damage
attributable to improper use.
CAUTION
Low voltage machines are components for installation in
machines in the sense of the machinery directive
2006/95/EC.
•
Do not use the machine until conformity of the
final product with this directive is established
(refer to EN 60204-01).
1.4 Qualified Personnel
All necessary work on electric drive units must only be
performed by adequately qualified personnel (for example,
electrical engineers as specified in draft EN 50 110-1/DIN
VDE 0105), who have the operating instructions provided
and other product documentation available during any
corresponding work, and who are obliged to abide by the
instructions contained therein. Qualified personnel are
persons who are authorised due to training, experience,
and instruction, as well as their knowledge of relevant
standards, rules, accident-prevention regulations, and
operating conditions.
1.5 Safety Precautions
WARNING
HIGH VOLTAGE
High voltage, which can lead to death or serious injury,
is present on the connectors.
•
Before working on the power connectors
(disconnecting or connecting the cable to the
OneGearDrive), disconnect the supply to the
frequency converter and wait for the discharge
time to elapse (see the frequency converter
operating instructions).
•
Installation, start-up, maintenance, and
decommissioning must only be performed by
qualified personnel.
1.6 Service and Support
Contact the local service representative for service and
support:
vlt-drives.danfoss.com/Support/Service/
Safety Warnings
VLT
®
OneGearDrive ExtensionBox
™
2
Danfoss A/S © 02/2015 All rights reserved.
MI75A102
1
1
