Danfoss VLT Decentral FCD 300, Руководство пользователя

Страница: 97 / 212

Decentral Solutions
Programming, FCD
300
Display mode IV:
This display mode can be called up during operation
if a change has to be made in another Setup without
stopping the variable frequency drive. This function is
activated in parameter 005 Programming Setup .
MOTOR IS RUNNING
50.0 Hz
24.3% 30.2% 13.8A
SETUP
12
Here the programming Setup number 2 will flash
to the right of the active Setup.
■
Parameter Setup
A variable frequency drive ’ s comprehensive work area
can be accessed via a large number of parameters,
making it possible to adapt its functionality for a specific
application. To provide a better overview of the many
parameters, there is a choice of two programming
modes - Menu mode and Quick Menu mode. The
former provides access to all parameters. The latter
takes the user through the parameters, which make it
possible to start operating the variable frequency drive
in most cases, in accordance with the Setup made.
Regardless of the mode of programming, a change
of a parameter will take effect and be visible both in
the Menu mode and in the Quick menu mode.
Structure for Quick menu mode v Menu mode
In addition to having a name, each parameter is linked
up with a number which is the same regardless of
the programming mode. In Menu mode, parameters
will be split into groups, with the first digit (left)
of the parameter number indicating the group
number of the parameter in question.
• Using the [QUICK MENU] key, it is possible to get
access to the most important parameters of the
variable frequency drive. After programming, the
variable frequency drive is in most cases ready
for operation. Scroll through the Quick menu
using the [+ / -] keys and change the data values
by pressing [CHANGE DATA] + [OK].
•
The Menu mode allows choosing and changing
all parameters as required. However, some
parameters will be "shaded off", depending on the
choice in parameter 100 Configuration .
■
Quick menu with LCP 2 control unit
Start Quick Setup by pressing the [QUICK MENU] key,
which will bring out the following display values:
50.0 Hz
SETUP
1
QUICK MENU X OF Y
001 LANGUAGE
ENGLISH
At the bottom of the display, the parameter number
and name are given together with the status/value
of the first parameter under the Quick menu. The
first time the [QUICK MENU] key is pressed after
the unit has been switched on, the readouts always
start in pos. 1 - see table below.
Pos. Parameter no. Unit
1 001 Language
2 102 Motor power [kW]
3 103 Motor voltage [V]
4 104 Motor frequency [Hz]
5 105 Motor current [A]
6 106 Rated motor speed [rpm]
7 107 AMT
8 204 Minimum reference [Hz]
9 205 Maximum reference [Hz]
10 207 Ramp-up time [sec]
11 208 Ramp-down time [sec]
12 002 Local/remote operation
13 003 Local reference [Hz]
■
Parameter selection
Menu mode is started by pressing the [MENU] key,
which produces the following readout on the display:
50.0 Hz
FREQUENCY
0 KEYB.&DISPLAY
Line 3 on the display shows the parameter
group number and name.
In Menu mode, the parameters are divided
into groups. Selection of parameter group is
effected using the [< >] keys.
The following parameter groups will be accessible:
MG.90.F2.22 - VLT is a registered Danfoss trademark
97