![background image](http://html1.mh-extra.com/html/danfoss/vlt-automationdrive-fc-301/vlt-automationdrive-fc-301_programming-manual_507840700.webp)
•
•
•
-
-
-
•
•
•
Bit Hex
Dec
Ext. status word
Ext. status word 2
Ext. status
word 3
Parameter 16-94 Ext. Status Word
Parameter 16-95 Ext.
Status Word 2
Parameter
16-99 Ext.
Status Word 3
29
20000000 536870912
Unused
–
–
30
40000000 1073741824 Unused
–
–
31
80000000 2147483648 Protection mode
No function
–
The alarm words, warning words and extended status words can be read out via a serial bus or optional fieldbus for diagnostics. See
also
parameter 16-94 Ext. Status Word
.
7.2 Descriptions of Warnings and Alarms
Depending on settings, FC 301/302 is able to give warnings or trigger alarms. Below, an extract of most common alarms and warn-
ings can be found.
The following warning and alarm information defines each warning or alarm condition, provides the probable cause for the condi-
tion, and entails a remedy or troubleshooting procedure.
7.2.1 WARNING 1, 10 Volts Low
Cause
The control card voltage is less than 10 V from terminal 50. Remove some of the load from terminal 50, as the 10 V supply is overloa-
ded. Maximum 15 mA or minimum 590 Ω.
A short circuit in a connected potentiometer or incorrect wiring of the potentiometer can cause this condition.
Troubleshooting
Remove the wiring from terminal 50.
If the warning clears, the problem is with the wiring.
If the warning does not clear, replace the control card.
7.2.2 WARNING/ALARM 2, Live Zero Error
Cause
This warning or alarm only appears if programmed in
parameter 6-01 Live Zero Timeout Function
. The signal on 1 of the analog inputs
is less than 50% of the minimum value programmed for that input. Broken wiring or a faulty device sending the signal can cause
this condition.
Troubleshooting
Check connections on all analog mains terminals.
Control card terminals 53 and 54 for signals, terminal 55 common.
VLT® General Purpose I/O MCB 101 terminals 11 and 12 for signals, terminal 10 common.
VLT® Analog I/O Option MCB 109 terminals 1, 3, and 5 for signals, terminals 2, 4, and 6 common.
Check that the drive programming and switch settings match the analog signal type.
Perform an input terminal signal test.
7.2.3 WARNING/ALARM 3, No Motor
Cause
No motor is connected to the output of the drive.
7.2.4 WARNING/ALARM 4, Mains Phase Loss
Cause
A phase is missing on the supply side, or the mains voltage imbalance is too high. This message also appears for a fault in the input
rectifier. Options are programmed in
parameter 14-12 Function at Mains Imbalance
.
Troubleshooting
Check the supply voltage and supply currents to the drive.
AU275636650261en-000101 / 130R0334
700 | Danfoss A/S © 2022.12
Troubleshooting
VLT AutomationDrive FC 301/302
Programming Guide