MG.60.C4.02 – VLT is a registered Danfoss trademark
15
VLT
®
6000 HVAC
■
■
■
■
■
Control unit LCP
The front of the VLT frequency converter
features a control panel - LCP (Local Control
Panel). This is a complete interface for
operation and programming of the VLT 6000
HVAC.
The control panel is detachable and can - as
an alternative - be installed up to 3 metres
away from the VLT frequency converter, e.g. on
the front panel, by means of a mounting kit
option.
The functions of the control panel can be
divided into five groups:
1. Display
2. Keys for changing display mode
3. Keys for changing program parameters
4. Indicator lamps
5. Keys for local operation.
All data are indicated by means of a 4-line
alpha-numeric display, which, in normal
operation, is able to show 4 operating data
values and 3 operating condition values
continuously. During programming, all the
information required for quick, effective
parameter Setup of the VLT frequency
■
■
■
■
■
Control keys for parameter Setup
The control keys are divided into functions. This
means that the keys between display and
indicator lamps are used for parameter Setup,
including selecting the display indication during
normal operation.
[DISPLAY / STATUS] is used for
selecting the indication mode of the
display or when returning to the
Display mode from either the Quick
menu or the Extend menu
mode.
converter will be displayed. As a supplement
to the display, there are three indicator lamps
for voltage (ON), warning (WARNING) and
alarm (ALARM), respectively.
All VLT frequency converter parameter Setups
can be changed immediately via the control
panel, unless this function has been
programmed to be
Locked
[1] via parameter
016
Lock for data change
or via a digital input,
parameters 300-307
Lock for data change
.
[
QUICK MENU] gives access to the
parameters used for the Quick
menu. It is possible to switch
between the Quick menu and the
Extend menu modes.
[EXTEND MENU] gives access to
all parameters. It is possible to
switch between the Extend menu
and the Quick menu modes.
[CHANGE DATA] is used for
changing a setting selected either in
the Extend menu or the Quick
menu mode.
[CANCEL] is used if a change of the
selected parameter is not to be
carried out.
[OK] is used for confirming a
change of the parameter selected.